What is EOL?

1 Answers  

---

A 6.6 KV/ 440V Xformer. what are the imporatant parts & equipment required for it's protection panel.

0 Answers   APTransco,

---

how to determine the size of power cable according to load current

1 Answers   JSW,

---

What is ELR, and where it is used ?

7 Answers   KSEB,

---

How can the direction of a three phase induction motor be reserved

4 Answers  

---

what is meant by tranformer impedance?

0 Answers   Synergy,

---

hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .

0 Answers   Vizag Steel,

---

What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?

0 Answers  

---

If Three Runs of 1Cx300 Sqmm Cable between Transformer and VCB and the distance between 100mtrs. what will be total length of Cable and if cost 1500Rs per meter,what would be the total cost

1 Answers   ANITS,

---

what is the basic need of domestic loads 1- voltage 2- current

0 Answers  

---

if a 2 ohm resistor,2 ohm capacitor and a 2 ohm inductor is connected parallely to 12v source.Then what is the value of current in each branch.Is current flows in each branch at the same time?If not so then provide the proper sequence

1 Answers   Tata Steel Limited,

---

why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.

0 Answers  

---