what is the operation of Control Module(CM),MONITOR
Module(MM), MONITOR Module DUAL (MM2),Signal
Module(SM),Isolator Module(IM), please some one reply me..
the operation and application of these in FIRE ALARM SYSTEMS...
Answer / asif.k64@hotmail.com
Modules work as a mediator between the fire alarm panels and
output devices like, smoke detector or MCP(manual call
point) actuators etc.
Control Module(CM)# Device Interface module
This Is an interface Module for automatic Switching or
Programmed outputs.
MONITOR Module(MM)# monitor module is an interface between a
control panel and normally open contact devices
MONITOR Module DUAL (MM2)# It is used for two wire
addressable devices, it can also monitor No contacts and
supervisory devices.
Signal Module(SM)#Signal modules (SM) to connect sensors and
actuators (Output devices) are the interfaces of the system
to the process. Digital signal modules acquire the binary
control signals to and from the process level.
Isolator Module(IM)# To protect the system against short
circuits, should be placed between each device on the
SLC (Signaling Line Circuit) loop to isolate a short-circuit
problem
| Is This Answer Correct ? | 39 Yes | 3 No |
How Many Safety of Transformer
what is High resistance grounding and whatis the criteria for the selection of High resistance grounding
power is the product of voltage and current.so we can measure the value of power just by using ammeter and voltmeter.......then why do we use a wattmeter?
TELL ME, WHERE SHALL I GET BASIC ELECTRICAL ENGINEERING BOOKS IN INTERNET?IT SHOULD CONTAIN ALL DEFINITIONS?
WHAT IS MEANT BY DERATING OF THYRISTOR?
why do we use LPF wattmeter not UPF in the experiment of no load and blocked rotor test of 3phase slipring induction motor?
when the size of the cable used for the ht voltage is 300sqmm then what is the size of the conductor of each phase
In an ammeter used for measurement of current, what is the meaning of the representation of range as '0-50-300'?
what is the difference between cable routing and scheduling?
Abb 11kv how it is closing automatically when the cb is racking in and rack out when it reaching test position
Is it legal of using 3 phase motors in 2 phase in Tamilnadu?
what is the apt definition for kirchoff's current and voltage laws?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)