Interested to Buy Any Domain ? << Click Here >> for more details...
what is the operation of Control Module(CM),MONITOR
Module(MM), MONITOR Module DUAL (MM2),Signal
Module(SM),Isolator Module(IM), please some one reply me..
the operation and application of these in FIRE ALARM SYSTEMS...
- 1 Answers
- 39210 Views
- I also Faced
- E-Mail Answers
Answer Posted / asif.k64@hotmail.com
Modules work as a mediator between the fire alarm panels and
output devices like, smoke detector or MCP(manual call
point) actuators etc.
Control Module(CM)# Device Interface module
This Is an interface Module for automatic Switching or
Programmed outputs.
MONITOR Module(MM)# monitor module is an interface between a
control panel and normally open contact devices
MONITOR Module DUAL (MM2)# It is used for two wire
addressable devices, it can also monitor No contacts and
supervisory devices.
Signal Module(SM)#Signal modules (SM) to connect sensors and
actuators (Output devices) are the interfaces of the system
to the process. Digital signal modules acquire the binary
control signals to and from the process level.
Isolator Module(IM)# To protect the system against short
circuits, should be placed between each device on the
SLC (Signaling Line Circuit) loop to isolate a short-circuit
problem
| Is This Answer Correct ? | 39 Yes | 3 No |
Post New Answer View All Answers
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
who invented active elements? plz give me the complte details of active elements...
what is high - pot test. what's its use?????
Is the theorem applicable to ac sources?
I need bhel electrical test pattern & paper
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
11 kv input, 66 kv input advantages
how many current required for hypo test
Which type of questions well asked. ?
What are the three types of compensators?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
What are the basic elements used for modeling mechanical rotational system?
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
