Answer / morsli

instrumentation job is to calibrate transmitters for exemple level ,pressure ,flow we use multimeter for the analog transmitter ,in smart transmitters we use a hart protocol .
other work is to calibrate pressure switch ,level switsh,temperature switch .
you adjust the valves switches ,on and off ,open and close.
you calibrate the valve with positionner ,pneumatic positionner or digital .
you deasmantel the pneumatic control valve ,and change the spare parts,the calibrate without positionner ,the open top at 3 psi and the close top at 15 psi.
you look for ground when there is a problem in instrument wiring.
you adjust the controller parameters PROPORTIONAL -INTEGRAL and DEREVATIVE when the controller is operating ,on line process.

how to calibrate any tansmiter by loop or hart calibrator

2 Answers  

---

Which type of pressure can be measured by these elements?

0 Answers  

---

what is the significance of hook up

3 Answers  

---

Why thermo wells are used?

1 Answers  

---

how to rectify the problem ,if we erected the DPT instrument wrongly of hp on lp side and lp on hp side?

5 Answers  

---

what is pt100 RTD, and does 100 stands for

8 Answers   Tata Power,

---

If Solenoidal valve works in manual mode but not in Auto mode. What should be the problem?

8 Answers   Bharathi Cement, Titanium,

---

What is the different between ESD & PLC.

1 Answers  

---

open tank and close tank leavel transmiter about range and calibration

0 Answers  

---

my temperature transmitter in field showing 700 degree , whereas in dcs showing 459 degree, how to resolve this?

4 Answers   ONGC,

---

why we are using pnp npn for sensors is there any other type?

1 Answers   CGL,

---

full process of gas turbin?

0 Answers  

---