Why cables and busbar both needed in LT Panels?
No Answer is Posted For this Question
Be the First to Post Answer
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
In Slip ring Induction Motor we use Liquid Rotor Starter for Starter Every Time Liquid Filling we need add Soda Sodium Carbonate or only Distilled water is Enough.
if u have to run a 300kw moter then what is ur choice HT or LT switchgear & explain why?
how to calculate the bus bar current rating
are there rmu for 3 transformer?
What is High Frequency Grounding????
why rotor resistance starter is not suitable for squrielcage induction motor?why it is suitable for slipring induction motor?
1)Why potential transformer primary site grounded? 2)can be loop between neutral & body for grounding? 3)What is the difference between ELCB &RCCB? 4)Why we use iron core in transformer insted of wooden core? 5)what is the principle of excitation? 6)Why we test the core balance test for transformer? 7)what is creepage?What is the creepage length for insulators at different voltages? 8)How much type of relays used for differential protection of generator,transformer & busbar protection?
what is the purpose of bypass mode in energy lighting transformer?
what is the concept of directional power?
What will happen if primary of transformer is fed with Square wave instead of sinsoidal wave ?Will it operate or Not?
What is the difference between earth resistance and earth electrode resistance?