5MVA TRANSFORMER SUDDENLY FAIL WITH THE PRV TRIPPING AND LARGE AMOUNT OF OIL S

5MVA TRANSFORMER SUDDENLY FAIL WITH THE PRV TRIPPING AND
LARGE AMOUNT OF OIL SPREAD OUT? SO IT CAME BACK WITH THE
REPAIRING WITH REASON THAT IT FAILS BCOZ OF TRANSIENT
EFFECT? SO PLZ EXPLAIN HOW DOES IT HAPPENED?

Question Posted / pankaj9371

1 Answers
4370 Views
I also Faced
E-Mail Answers

5MVA TRANSFORMER SUDDENLY FAIL WITH THE PRV TRIPPING AND LARGE AMOUNT OF OIL SPREAD OUT? SO IT CAM..

Answer / k.prakashchandra

The insulation failure was detected and it was attributed to
high transient voltages.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is the significance of tan&delta and how it performed in power transformer

0 Answers

Piezoelectric materials serve as a source of:- A. Microwaves B. Ultrasonic waves C. Musical waves D. Resonant waves

3 Answers

A 100 MVA transformer may be cooled with?

6 Answers HCL,

As we know multiplicity factor derivation equation is as below MF = main c t ratio / main p t ratio * meter c t ratio / meter p t ratio * meter dial constant Where in digital meters for HT kwh import export now a days meter constant are calibrated already which is 1 So my question is For HT 11kv 110 v line values are as below Main c t and p t ratio are 11000 v and 110 v and 20/5 means 20 amp and 5 amp Now meter values are 11000/√3/110√3 and primary and secondary amp are displayed as -/5 amp on kwh meter so what will be the MF for this meter ?

1 Answers NEPC,

hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.

0 Answers Hyundai,

1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.

0 Answers

If single phase supply is 220v. then why three phase supply is 660?

2 Answers

What is mathematical model of a control system?

0 Answers

why neutral busbar size is SAME of the phase busbar size UPTO 200A IN LT PANELS

1 Answers IBS,

when is the Ohms law is applicable?

11 Answers ABB,

why the value of impedence is taken as %impedence in fault currrent calculation

1 Answers

what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks

0 Answers

For more Electrical Engineering Interview Questions Click Here