I have a MRE200 amplifier for controlling a mitsubishi
servo motor, I would like to know how many pulses are
required to rotate the servo motor by 1 degree and what
must be the pulse width
Answer / kuber
for this we need the no. of poles for the servo motor. then
speed of the servo motor = 120f/p
then cycles required for one rpm f = p/120
then we can derve the cycles for 1 degree revolution
Is This Answer Correct ? | 1 Yes | 1 No |
Hi buddies! i am facing a problem and if someone could help me it will be an immense pleasure to me. we have compect logix PLC 1769 2L AO module to Heat @ 52 to 56 Deg C .So if anyone can do please help me out with this problem.I'll be highly grateful.
I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.
How to calibrate DP tramitter in flow measurement application? consider my range of flow is 0 to 2000 kg/hr ? please give calculation of , How much pressure applied on low pressure side and high pressure side please give detail of calculation .... It so important for me please reply as soon as possible
what type of cables are used for f&G systems and detectors, what is the standard colour?
Where is wet leg is used?
In oil & gas industries and petrochemical industries, there are classification of zones like zone 0, zone 1, zone 2. Is there any differences in voltages or power supply supplied for the process instruments, control instruments depending on the zones
selection of the zener barrier for the hazardeous area zone 0
what is interface level and how it is calibrate?
What is rtd output signal
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
My question may be very basic or childish but this question still persists in me, someone plz help me 1.why do we go for differential equations to analyze a system? 2.why do we solve it using matrices, is there any specific reason for using matrices other than the stories like it is simple,faster etc.