WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY
DIFFERENT I CONTROL VALVE TRIM DESIGN
No Answer is Posted For this Question
Be the First to Post Answer
How does a redundant controller comes in line when the main controller fails??
How to calibrate and check thermal mass flow meter of Make thermal instrument company inc model 60?
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
How Honeywell FSC is functioning and what is its purpose? Can we bypasa it and only use DCS instead of that.
What is the working principle of Dozing valve used in cement industry?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
What is the reason PT speed not incresed in gas turbine?
Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?
A pressure differential gauge type of instrument has a manifold with 2 isolation valves (hp and lp),2 vents(1 each for hp and lp) and 1 equalizing valve. Determine the position of each valve(either fully closed or fully open) when troboulshooting to: 1. zero the transmitter. 2. determine if there is a block in the impulse line. 3. determine if the gauge is functioning properly. The process fluid is water.
why 4 to 20 ma? why cant some other range?
what is interface level measurement.who can calibrate interface level measurement transmitter online