suppose we have a tendency to make a hole on the surface of the beam, than wher

suppose we have a tendency to make a hole on the surface of
the beam, than where we goes to make it?

Question Posted / karthickrock1991

3 Answers
7093 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

suppose we have a tendency to make a hole on the surface of the beam, than where we goes to make it..

Answer / karthickrock1991

we choose the place, where the deflection is zero, i.e at
the point of contra flexure. otherwise it`s leads to collapse

Is This Answer Correct ?

18 Yes

2 No

suppose we have a tendency to make a hole on the surface of the beam, than where we goes to make it..

Answer / ashutosh

in the design of RCC beam we design it as a crack section neglecting the area of concrete below the neutral axis so we can make a hole in concrete in the area below the neutral axis .

Is This Answer Correct ?

1 Yes

1 No

suppose we have a tendency to make a hole on the surface of the beam, than where we goes to make it..

Answer / n sudheer

center of beam

Is This Answer Correct ?

0 Yes

4 No

Post New Answer

More Civil Engineering Interview Questions

how much dry volume of cement in 1cum in m20 grade

3 Answers

Dear sir, i want to NBCC & NTPC previous exam papers email Id : madhu_bingi@yahoo.co.in

0 Answers NTPC,

what is meant by camber

1 Answers NCC,

Why do not use fly ash bricks for waterproofing.

3 Answers ABB,

why we used shahabad stone (ladi) in box type water proofing.what is the main roll of shahabad stone?

2 Answers

what is difference between long column and short column?

16 Answers L&T, Tomi Polytechnic,

What are the Types of foundation?

1 Answers

What is the cost difference between site mix and ready mix concrete per cubic meter

0 Answers L&T,

How many cum of 9.5mm stone in 1 ton ?

0 Answers GT Realty,

how to Concrete cubes testing curing time 7 days casting date 24.05.17 testing date ?

0 Answers

Is there any codal provision stating the actual diameter for chair bars?

1 Answers CADS Software,

difference b/w stress and strength

3 Answers BMS,

For more Civil Engineering Interview Questions Click Here