Answer / syed javeed basha

Isolators are those switches which disconnect (isolate) supply to any particular section. usually these are manually operated during maintenance of transformers or busbars etc.

busbars are those metal strips or hollow pipes which pass current in a substation or grid.

Answer / tapiwanashe vhurumuku

An isolator is a switch operated manually which disconnects power from the main supply

What are the classifications of heating element?

0 Answers   BARC,

---

To measure insulation resistance of 11KV cable between core & armour, what should be the test voltage & duration?

4 Answers  

---

how to compare with Relay settings for HT&LT panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps

0 Answers  

---

Size of the power cable like 1.5,2.5,4 sq.mm which area calculated from whick area or how specified the size?

1 Answers   MRF,

---

How to design grid earthing

1 Answers  

---

What happens if fuse is connected to neutral wire

9 Answers   HAL,

---

If the battery is in charging condition means, battery is which type of load? Capacitive or Resistive load?

2 Answers   Crisp,

---

why we multiply 11 in High Electric supply?(eg.11KV, 33Kv, 330Kv etc.)

3 Answers  

---

ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?

0 Answers  

---

in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.

0 Answers  

---

what is the name of transformer oil.

15 Answers  

---

how digital four pin earth resistance tester works

2 Answers  

---