what is the correct method for the outdoor termination of
19/33 KV HT cable step by step?
No Answer is Posted For this Question
Be the First to Post Answer
How REF protects transformer alone? explain with diagram.
The Frequency is measured by _________ bridge ?
What is the significance of %Z in case of transformer?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
we have one pumping station and 4.6 MW 7 no.s synchronous motors.so there is no required HT capacitor to improve power factor.But we have two no.s of 25 Mva power transformer connect to distribute the power for motors connect with 220 kv line.So i have required the HT capacitor to improve power factor at HT side i mean power transformer bus side.So please suggest how much HT capacitor banks required for same.
what do you mean by star connection?
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
What will be done if we open the secondary of CT on load??
The cable area of cross section is 185 sq mm. How to convert this to the diameter.
1-What is the difference between absorption factor and polarization factor in insulation resistance test in transformers? and why we inject until ten minutes to get polarization factor?
How much load can give on 1600 kva transformer 11kv/440
How Diesel Generator start ?
0 Answers ITC Infotech, Voltech,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)