I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD
SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF
NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ?
DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN
WHY THERE ARE MARKED LINE & LOAD ON MCCB.
No Answer is Posted For this Question
Be the First to Post Answer
what will happens if one phase is missing for 33/11kv power transfomer and why?
What are the possible causes of REF operation on a power transformer
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
In a Dyn11 transformer, how are the 3 windings of the delta connected? Assume that R1-R2, Y1-Y2, B1-B2 are the 3 windings on the HV side.
A low wet bulb temperature indicates
where used of HVDS system.
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
What is balance beam relay ?
what is the cost of a analog tachometer, for lab purpose/
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what type of motor is used in fan
How Flywheel run in DG set, tell in details
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)