Interested to Buy Any Domain ? << Click Here >> for more details...
why armature is placed in stator but not in rotor in
synchronous generator ?
- 2 Answers
- 4093 Views
- Student, I also Faced
- E-Mail Answers
Answer Posted / i.m.sayad.
To draw out generated voltage easily and economically than
using brushes,slip ring.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
What are the transformer losses?
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
what happen ehen synchronisation is done at below rated speed
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
How to define Kirchhoff current law and voltage law along with simply examples.
what are the pecularity of shaver sockets ?
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
What is an automatic controller?
what is the meaning of impedance protected in instrument cooling fan
How to calculate Air conditioning capacity for a telecom BTS shelter?
if i am in front of transmission line how to know that current direction without any equipment
in science exhibition how lamp can blink when you clap near the lamp ? thank you
What is EMC filter in VVVF Drive ?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
