Interested to Buy Any Domain ? << Click Here >> for more details...
how many mega ohms insullation of the cable can't be use
when testing with megger tester for Low voltage cable 240V
use?
- 3 Answers
- 6173 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
Without armour you can not get the correct IR. Larger the
area of conductor the thicker is insulation layer and you
have to use 500 V megger which will read not less than 5 M ohm.
| Is This Answer Correct ? | 3 Yes | 0 No |
where does the unbalanced current flow in the delta circuit
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
It is observed that AVR of an Alternator is more likely to fail if the Generator and Mains Neutral are directly connected to each other. Why should this be so?
How to calculate cable size between battery charger to Battery ?
How the starter control the starting current in three phase AC Motor?(In DC apply the reistance).
what are the advantages of having high voltage in transmission lines?
How are calculated the aluminium busbar cross section area?
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
What types of testing in 11Kv Ht switchgeat during testing?
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
which is better ac or dc?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
-
Civil Engineering (5086) - Mechanical Engineering (4453)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
