It is observed that AVR of an Alternator is more likely to
fail if the Generator and Mains Neutral are directly
connected to each other. Why should this be so?
Answer / k.prakashchandra
The voltage in neutral of gen during earth fault will be fed
to the neutral of AVR which may get damaged , being an
electronic equipment
| Is This Answer Correct ? | 0 Yes | 0 No |
Can we use same copper cable for both AC & DC power.
What is the deffirant between EARTH, GROUND AND NUTRAL
what s a servo motor? how to control the servo motor? and its application, purpose of using?
How can we measure the frequency of a rotor running in full load condition? Explain the method of measuring.
why we use single core 630mm2 cable for transformer secondary side
wat is mean by HRC fuse... WHY we choose it...?
CAN WE GENERATE AC WITHOUT DC EXCITATION?
how does oil cools the transformer
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
Transfer of electric power from primary to secondary in a transformer takes place A electrically B magnetically C electro-magnetically D conductively
What is High Frequency Grounding????
why we testing the core balance of the transformer before comissioning?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)