Answer / dinesh.rk

> simple.. the moment (created by force x distance) the
tends to bend the structural/ any other member.
2 cases are - positive (sagging)
- negative (hogging)/

this can be explained by:
consider a rcc(singly reinforced) beam- in which the
bottom of center span (+ve) and top of support (-ve)
section are reinforced to taking care of BM/

Answer / guddu singh

If their are a loaded
beam. Than take any
cross section on
it. Right as left
side of section moment
of forces reference to
the section called
bending moment.
Because this un
balance moment try to
bend the beam about
that section.

Answer / yuvaraj murthi

the load which enable the member to bend or moments produced due to loading

how much cost of single coat 20mm thick plastering per sqre meter

0 Answers  

---

How we decide the the load combinations for design of RCC structures?

7 Answers  

---

Define block?

0 Answers  

---

A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals

0 Answers  

---

In Residential home construct footing,beam, column,lintel,rcc roofs which dia rod used how to self assumed

0 Answers   AG Technologies,

---

what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete

0 Answers  

---

what is BPM in concrete demolition hammers. what is better a higher value or lower

0 Answers  

---

what is diversion?

0 Answers  

---

Sir please Bhel Enigineer trainy test papaers in civil engineering

1 Answers   Bhel,

---

a wall having area 100 sqft and bricks size 19cm*9cm*9cm so how many bricks required...

14 Answers   Jain Group,

---

What is the difference between built area and super built up area?

0 Answers  

---

flow of fluid takes place viscosity compressibilityu surface tension deformation under shear force

0 Answers  

---