Answer / jayesh patel

We can select contactor according to the load. It there is
Inductive load we can select as Per AC3
For resistive load we can select as per AC1 Duty
For capacitor switcching we can select AC4 Duty

Electricty is generated at around 16kV, then step up to 220kV for transmission then steped down to power transformers then DTs and then through the LT n/w it reaches the consumer end. At the consumer end 230V supply is required. So, why is electricity not generated directly at 230V and transmitted?

4 Answers  

---

What is the standard height of installation of Socket & switch from Finish Floor Level as per the IEC/IS Rules?

1 Answers  

---

what is d meaning of inrush current of a trafo ? how u can calculate this ?

1 Answers   Jindal,

---

If a generator of generating station produces 100MW rated output then what will be the rating of the step-up transformer connected to it?

5 Answers  

---

We have three 33kv substations. All of them energised by same source.When i am checking the phase sequence between one substation to other substation (like R Phase to R Phase) by multimeter i am getting some voltage.Near to LT panels UPS panels are there. Can u explain whether any possible to happen like that. In Phase SEquencemeter is showing correctly in both substations. How is it happen. Explain me.Explain me communication signal will produce Phase difference on this case.

3 Answers  

---

1.wat is the advantage of induction motor? 2.wat is diffrence between 1-phase and 3-phase induction motor?

2 Answers  

---

What is meant by coupling capacitor?

0 Answers  

---

iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A. Resistors of 2.52 ohms and 1.64 ohms are connected in series with the armature and in parallel with the armature respectively. The field excitation remains direct from the 460V supply but the generated torque is halved. Determine the new running speed. Neglect brush voltage drop. The armature resistance is 0.4 ohms. [15]

1 Answers  

---

Why used in layer by layer charcoal and salt used in earth pits.

11 Answers   CESC, HP,

---

What are differences between Conventional & Addressable type smoke detectors?

1 Answers  

---

As a good company employee, can you report your supervisor to the company management if he or she is going against the company interest in his or her actions?

1 Answers   MAHINDRA,

---

Which type of power plant is more easier to produce electrical power at economical condition?

8 Answers   HAL,

---