can we run three phase motor by single phase? and what
happens if we do this
Answers were Sorted based on User's Feedback
Answer / sameer
No, If we do this nothing will happen motor rotor remain
stop on their stand still position, because single phase
supply does not produce revolving magnetic field which is
essential for rotating the rotor.
we can do this if we have two phase supply.we make open
delta connection by using two phase supply and gets 3 phase
supply and then we supplied it to motor 3 phase rotor.
| Is This Answer Correct ? | 25 Yes | 4 No |
Answer / vikram
no we cant run 3 phase motor with single phase, if we do so
nothing will happen, even motor does not produce any noise
because single phase supply can't produce magnetic field to
produce the torque to rotate the rotor.
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / satyapal prajapati
yes we can run three phase motor by single phase with the
help of capacitor. the motor rpm and capacity reduces
| Is This Answer Correct ? | 7 Yes | 4 No |
Answer / kiran2393
yes we can run 3 phase motor by single phase using capacitor
| Is This Answer Correct ? | 2 Yes | 0 No |
S we CAN a single phase supply can not produce
rotating magnetic field BUT it produce alternative
magnetic field. It can start with low starting
torque if we give prime move(starting means) to
that motor
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / adinarayana
yes it will possible but three phase motor hp reduses and
it will run same speed
| Is This Answer Correct ? | 3 Yes | 6 No |
What is the main use of rotary phase converter ?
how much Hp motor is required for water suction pump in home uses ?
1.differance between onload ups and off line ups.
why induction motor always operate at lagging p.f.?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
Why the vector group of excitation transformer in static excitation system is Dy5?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done
why we use tapechanger in primary side of transformer
what is difference b/w bus duct & bus bar.
how to improve power factor correction?
What are documents to be required for export of the material?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)