As a good company employee, can you report your supervisor to the company management if he or she is going against the company interest in his or her actions?

3 Answers  

---

Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???

0 Answers  

---

1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?

0 Answers  

---

physical identification of HT & LT panel

0 Answers   Schneider,

---

what is the reasons for blowing fuse

1 Answers  

---

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers   TATA,

---

how many joint can done in HT line and what is life of the joint

0 Answers   Micro Labs, Reliance,

---

How can a equal potential zone be carried out in conductors?

0 Answers  

---

how to compare with Relay settings for HT&LT panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps

0 Answers  

---

1 hp single phase motor is more likely to get hot thsn inone hp 3 phase motor its true or false? If true why?

1 Answers   TVS,

---

Can we use MCCB with Auxiliary Contact in place of Contactor in a AMF System.

1 Answers   C&S, Farnek,

---

what is electrical machines

1 Answers  

---