Answer / lokesh raj

AN EXCITED OR OVER EXCITED GENERATOR PRODCUES COMPARETIVELY
HIGHER VOLTAGE AND HIGHER CURRENT, BUT FOR CONSTANT LOAD
V*I*Cos(angle) IS CONSTANT. AS VOLTAGE AND CURRENT IS
INCREASED V*I*Sin(ANGLE) THAT IS REACTIVE POWER.

AS THE EXCITATION INCREASED THE REACTIVE POWER INCREAED.

Answer / k.prakashchandra

Reactive power(leading) also increases when excitation is
reduced

advantages of vvvf drives over non vvvf drives for EOT cranes

2 Answers  

---

TYPE'S OF BREKAR ,WHAT IS TRANSFORMAR & SAFTY. STARTER DOL & STAR DELTA STARTER.

0 Answers   Amtek,

---

what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:

0 Answers  

---

what type of oil is used in transformers? a)conduting b) insulating

25 Answers   ABB, LGS,

---

sir i had plane to do some project with the base of hopkinson test in AC supply its possible

0 Answers  

---

---

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers   TATA,

---

How the speed of synchronous motor changes with the variation of load?

1 Answers  

---

How can we calculate the capacity of the capacitor bank attached with the Main panel, when we know the capacity of the panel installed in KVA Rating?

2 Answers  

---

What do you mean by reach and reach the point of the relay?

0 Answers  

---

What is the reason that the humming sound is coming from the induction furnace panel?

0 Answers   SKS Microfinance,

---

how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.

0 Answers   OPS,

---

WHAT ARE THE BELT HORMONICS IN AC MACHINE HOW TO REDUCE IT

2 Answers   DRDO,

---