What is protocol ?
Answers were Sorted based on User's Feedback
Answer / gopalakrishnan
Its a set of rules and regulations for communication for
both DCS and PLC.
Is This Answer Correct ? | 13 Yes | 5 No |
Protocol is a set of rule following which, the
communications take place. This communication can be
between field instrument and controller like DCS, PLC or
within LAN, WAN, VPN etc....
Is This Answer Correct ? | 6 Yes | 1 No |
Answer / dineshkannan
that is protocalmean by range in signal to filed to
marshaling cabinet .in distrubutdd control system and
program logic controller ....
Is This Answer Correct ? | 3 Yes | 19 No |
how to convert digital signal to analog signal in plc
in my plant 100% feedwater control v/v is air to close but due to instrument air fail,the valve opens but instead of drum level high its get tripped in low low drum level.the urv of level tx is 0 and lrv is -800.pls tell me the reason. for such behaviour.
Explain " FAIL SAFE " feature in temp. measurement.
1 Answers Bapco Bahrain Petroleum Company,
SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?
What is the difference between Pressure Safety Valve and Pressure Relieve Valve, in what condition we prefer choose Pressure Safety Valve rather than Pressure Relieve Valve? and vice versa
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
why can't we use 5-20mA standard or some other instead of 4- 20mA?
Can we use a 10000 Lph Flow Transmitter in 100 LPH flow line to get 20mA O/P by adjusting SPAN ?
Explain the mechanism behind the turbine meter.
Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?
Explain bernoulli’s theorem.