Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / indrajit.p
Protocol is a set of rule following which, the
communications take place. This communication can be
between field instrument and controller like DCS, PLC or
within LAN, WAN, VPN etc....
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Whatis the reset ofset and control system in instrumentation
what is the difference between scaler and vector drive
how to calibrate 0- 150 psi presure gauge by dead weght tester
what is cold loop? difference between hot and cold loop?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
What is 3 selection available when configure the burnout protection for controller
Why ac supply load cell is used? Can we use the dc supply load cell?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
Explain plc level and its type?
what are the use of belew gear in general ??
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
Specific gravity.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
