Answer / bharani

When you isolate yourself from the ground by standing on an
insulator and touch a live wire, depending on the
resistivity of the inulator, a small current may flow
through your body to the ground and if it is negligible, you
may not feel anything. but if you wet your body and carryout
the the same experiment, then you may be at risk of a shock
as yor body resistance would have come down drastically.All
said and done, the resistivity of the material chosen as
inulator is very important.

Answer / sourav pal

It depends,
1.Condition of body(non Linear Resistence) either wet condition or Dry condition.
2.Voltage Capacity(high/low)
3.On which insulator(capacitance) are u standing and touching the wire

Voltage drop is the:(a) Maximum potential(b) Difference in potential between two points(c) Voltage at the end of a circuit(d) Voltage produced by a source

3 Answers  

---

how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take

0 Answers  

---

in gen traf what is ONAN , ONAF , OFAF and DYN

3 Answers  

---

5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch

0 Answers  

---

where we sense the fault from the transmission lines?any operation example for distance relay?rear panel connection for this relay?

1 Answers  

---

---

A 2083kva AVR was tested, phase to ground shows continuity, what is the implications

0 Answers  

---

Can i use the B-curve MCB instead of C-curve MCB

0 Answers  

---

inductive power factor is benefit compare to capacitive????

3 Answers  

---

how to calculate the bus bar current rating

2 Answers  

---

What is stepper motor?

0 Answers  

---

What is the power plant or power station?

1 Answers  

---

where we use 1 phase & 3 phase supply ?what is major advantage using 3 phase over than single phase ?

3 Answers  

---