what are the factors to be considered while design the
breaker either HT or LT??
No Answer is Posted For this Question
Be the First to Post Answer
How to use a insulation resistance tester on a three phase electric motor?
what is the difference between skin effect
why we cannot apply ohms law to transformer?
why transmission is only 3 phase and not 2 or 4 or poly phases
why we r used APFC Panel in industrial area.when P.F. low then wat will be the effect in our system?
10 Answers ABB, Georgio Rocks, Piramal Healthcare, Zenith Engineering Corporation,
what is meant by leakage current of a capacitor?
300m long and 30kw inductive loade 3phase supply how many size cable required
while calculating the power absorbed by a resistor connected to the output of a half wave rectifier circuit should we use rms or average current? explain with reason.
What is the significance of integral controller and derivative controller in a pid controller?
How I design capacitor bank for different load.7MW connected load.
What is tranformer differtial?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)