The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
No Answer is Posted For this Question
Be the First to Post Answer
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
In 3phase supply Voltage will come around 370v then what will happen?(mean what will effect on electrical equipment like AC,UPS,Motors.)
how the transformer stables out zone faults? Because we use non directional O/C relays .Is there any special considerations are taking into account to overtake this?
where we sense the fault from the transmission lines?any operation example for distance relay?rear panel connection for this relay?
4.In which type of welding is a pool of molten metal used.....
3 Answers ISRO, SSC, Vizag Steel,
why we use end termination xlpe cable on ht kit
i want to know how to calculate the battery capacity based on the UPS . ex i want to run have one kva UPS Which should run 10 hours ? in that case how many batteries to be installed and what will be the AH Value .
Why the high starting current does not harm the low capacity induction motor?
State how to produce a constant rotating field by application of alternating currents to stator armature of a three-phase squirrel-cage induction motor
what is difference between c-power & u-power air circuit breaker?
2 Answers Areva, IIT, Marine Electricals,
what is the difference between Earth and neutral? and what is the difference between ground earthing and neutral earthing?
what is the chemical reaction of solt and charcoal in earthing?