how to mesure the earth pit value and what is the minimum
value of single earth pit?
- 3 Answers
- 5286 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahaveer sahu
Earth pit value can be measured by digital earth tester and the minimum value of single earth pit should be less than 2 ohm
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Is the theorem applicable to ac sources?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
why and where we use early make & late break contacts in protection?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
state basic meaning of 'INDUSTIAL AUTOMATION'?
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
What is difference between Over Current & Earth Fault protection?
What is difference between YNyn0 and YNyn ??
What is the meaning of HT Trivector Meter ?
Lt motor sfu flashing reasons?
What is the general power factor & min. power rating of TV,LCD type TV, CRt type TV, Scanner, printer?
Define closed loop control system.
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
Why saturation region slowly shifted in the left side?
