Answer / karun

Inverse Definite Minimum Time Lag = IDMT relay

It's a electromagnetic type rotating disk relay.

Tripping time of relay decreases with increasing fault current.


Read more:
http://wiki.answers.com/Q/What_is_idmt_relay#ixzz18ZiYIQIj

what is the name of transformer oil.

15 Answers  

---

What are differences between Conventional & Addressable type smoke detectors?

1 Answers  

---

What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.

0 Answers  

---

We in my plant one of the transformer showing neutral to earth voltage is 22V how to solve it

3 Answers  

---

How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?

0 Answers   ABB,

---

What is the difference between PT for metering and PT for protection ?

3 Answers   Dewan Cement,

---

Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks

0 Answers  

---

Dear sir, I am working in wind mill division , pls explain Pls explain in details with formula My question is Wind speed 3.5 M/s Gen RPM is 1500 ( 25 K/w Production ) Wind speed 12 M/s Gen RPM is 1500 ( 220 K/w Production ) Why in 3.5 m/s generation was low , why in 12 m/s generation was high , Pls dont explain wind force or wind density , that one already i know For the above question RPM was same why the KW was different Answer : 1. Its depends on the density ( Force ) of the air Sir , Pls explain wit Formula sir

1 Answers   Vestas,

---

last week we did the REF relay test by closing single pole (R phase) of CB and apply 380V at the primary of delta transformer. we get 33A at the primary of the R phase star end. but we get 380A at both R an B in delta side. how and why?

1 Answers   Siemens,

---

my N-P 230 VAC at 3 wires but i haven't any voltages at phase to phase whither my supply is 3 phase, why i haven't received these line to line voltages ?

2 Answers  

---

What is Minimum permicible meggering value for following 1) LT Panels (Ph to Ph / Ph to Earth) 2) 11 KV, HT Panels (Ph to Ph / Ph to Earth) 3) 11 KV Cable 4) LT Cable

1 Answers   BFL,

---

hou we find and calculate the maximum lode capesity of transforer?

1 Answers  

---