Interested to Buy Any Domain ? << Click Here >> for more details...
Close loop and open loop diagram for instrumentation
- 1 Answers
- 6751 Views
- Petron ltd, I also Faced
- E-Mail Answers
Answer / sivakumar.s
with feed back is called closed loop
without feed back is called open loop
| Is This Answer Correct ? | 6 Yes | 0 No |
What properties or parameters to be taken into consideration for protection while selection of Dcs controller.
What will the new flow factor if D/P Transmitter is RE-RANGED from 25" WC to 50" WC
how to check earthing,what is minum ohms for proper earthing
why 4-20 mA signal is preferred over a 0-10V signal
How earthing can be checked????
what is the analog input , analog output , digital output, digital input geven to the MSSV , CBD, IBD , START UP VENT , BOILER FEED PUMP , AOP, CEP , ETC
1 Answers Bharat Biotech, TATA,
what is novram ic number of foxboro 762cna microcontroller ?thank
different between calibration range and instrument range ?
how to online calibration of remote seal tx.
What is T4 temperature in compressor?
why does a transmitter o/o signal starts from 3-15psi or 4- 20mA?
3element
-
Civil Engineering (5086) - Mechanical Engineering (4453)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
