what is the terminal voltage of dc series generator running
at rated speed at no load?
Answers were Sorted based on User's Feedback
Answer / nithi
we can get only residual voltage across the terminals(due
to residual magnetism).dc series generator cannot build-up
it's voltage without the load.
ONE INTERESTING FACT IS,
DC SERIES MOTOR SHOULD NOT BE STARTED WITHOUT LOAD WHEREAS
DC SERIES GENERATOR CANNOT BE STARTED WITHOUT LOAD.
OK...............
Is This Answer Correct ? | 14 Yes | 0 No |
Answer / senthilkumar
the high should be follow so, the series generator has a
load to run a generator
Is This Answer Correct ? | 1 Yes | 1 No |
what will be the min and max voltage flow from neutral to earth?
what is meant by generator differencial protection?
How can we calculate No load and full load torque of electrical machines, i.e. motor or alternator?
What are safety features considered for Lifts during emergency?
3.7 kw motor ,how much sq mm cabel want to bare this motor load
explain maximum demand factor
What is the inside of ACB & VCB & SF6 breaker's pls tell me about this
What are the advantages of speed control using thyrister?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
Why we use neutral cable just half from phase cable.Tell me briefly,please.
Hi How can you start-up the 40w tube lite with 230v AC/DC without using any choke/Coil.
what is your majour contributions in your present job