int a,b ; a=b=10 ; if(a>b){ printf ("%d",a)}; no error output

int a,b ; a=b=10 ; if(a>b){ printf ("%d",a)};

no error
output is a=10

Question Posted / king

2 Answers
3623 Views
TCS, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

int a,b ; a=b=10 ; if(a>b){ printf ("%d",a)}; no error output is a=10..

Answer / k.prakashchandra

no error. but as the 'if' condition fails, the printf part
is not executed. this program gives only the output screen.

Is This Answer Correct ?

4 Yes

1 No

int a,b ; a=b=10 ; if(a>b){ printf ("%d",a)}; no error output is a=10..

Answer / king

plz anybody apt explanation for this

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?

0 Answers HPCL,

what is pressure relief valve?where it is used????

4 Answers Mecon,

In a 11000/440 V transformer, when any one phase of 11 KV supply fails (ie., single phasing), what happens to the secondary voltage and why?

3 Answers Secure Meters, TCS, Torrent Power,

what will be the effect if you were using different brands of outlets?

0 Answers TESDA,

what is difference between short ckt and overload?

6 Answers Siemens,

why excitor coil of an alternator can fail

3 Answers

I have suguna 3 hp pump for my agreeculture work.It deliver the water from 45 feet well .I suffered by powercut.During powercut i got 2phase supply only .My question is can i run the pump in 2 phase supply using capacitor?.Can u explain me how to connect the capacitors?

2 Answers

Classical power system stability was mainly focussed on rotor angle stability but modern power system stability has more focus on voltage stability.Why?

4 Answers

what is meant by impedance & transient protection?

0 Answers

what is T P N bus bar

1 Answers

how to connect generators in parallel and what are the required equipment to do so?

2 Answers MSEB,

1 hp is equal to how much watt?

0 Answers Blue Star,

For more Electrical Engineering Interview Questions Click Here