Interested to Buy Any Domain ? << Click Here >> for more details...
Which type of material analysis in GC using Theramal
conditivity detector ?
- 7 Answers
- 11870 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / akj
the question askesd is totally wrong
tcd is used for the detemination of actual content of any chemical and solvent
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / navneet nehra
The Thermal Conductivity Detector is commonly used for
fixed gas analysis (O2, N2, CO, CO2, H2S, NO, etc.) where
the target analytes do not respond well on other, more
sensitive detectors. The TCD can detect concentrations from
100% down to around 100 ppm .
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / a.prabhakar
There is no universal detectors available for analysis. few compounds are highly responded and few compounds are may not be detected on the same detector. TCD is useful for which compounds have thermal conductivity.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / venkatesh
TCD Detector using only packed columns, in TCD Detectoroxygen,nitrogen, helium gases performed,and same compounds water content in GC analysis in TCD detector
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / s.sivamallayya
ACCORDING TO HPLC "TCD" IS USED FOR DETECTION OF
POLYMERS ,CARBOHYDRATES .
SO IN G.C., WE ANALYSE SOLVENTS OF TEHSE COMPOUNDS ONLY.
| Is This Answer Correct ? | 0 Yes | 1 No |
How to calculate signal to noise ratio by this formula 2H/h where h from where and how to measure
What is Rf value& Rx value in TLC?
what is peak purity and its formula
In HPLC what is Single point threshold, peak purity index and minimum peak purity index? what should be consider for pure peak.
What is the diffrence in japan mkt requirement in analytical method validation over US?
What is zero water in TOC Analysis?
what is the peak purity concept?
5 Answers Graviti Pharmaceuticals, Vimta Labs,
Why we are performing wavelength accuracy at lower and higher wavelengths in HPLC calibration
Explain what is a base line?
What is the procedure for investigation of an OOS (Out of specification) results?
4 Answers Biocon, Dr Reddys, Reddy Labs,
why we are using polystyrene film for calibration of I.R spectroscopy?
12 Answers Abbott, Andhra Organics, Intas, Kemwel, Reddy Labs, RRR, Veritas, Zydus Cadila,
signifcance of detector lenearity in calibration f hplc
Organic Chemistry 
