what will happen to the core losses if we perform the open ckt test on high vo

what will happen to the core losses if we perform the open
ckt test on high voltage side of a transformer ?

Question Posted / rakesh

2 Answers
4893 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what will happen to the core losses if we perform the open ckt test on high voltage side of a tran..

Answer / harishchandrasinh

only we required h.v rated voltage n does not effect core
loss which remains same if hav u any difficulty than send me
mail i will give my best........thank u

Is This Answer Correct ?

1 Yes

0 No

what will happen to the core losses if we perform the open ckt test on high voltage side of a tran..

Answer / eswara rao ch

Nothing but if we made the measurement on HV side it requires HV meters to find the same iron losses as found in LV side test which cause difficulty & expensive.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What are m circles?

0 Answers

What is the different between buchholz relay and pressure relief device?

2 Answers

How do we measure earth fault current in Generator Transformer(20/420kv),Station Transformer(20/11 kv) and Unit Transformers(20/11kv) for our plant system, since these don't have any Neutral earth Fault relay connected to their Neutral Earth? But for Unit Service transformers(11/.433 Kv) we have an Earth Fault Relay connected to its neutral earth.Why is such so?

1 Answers NTPC,

how fan speed decrease or increase by using regulator? thank you

3 Answers

What Normal(Tangent) towers and Tension(Cut-point) Towers?

1 Answers ABB, BGR Energy, NTPC, Powermec,

why different series of vfds (like allenbradley)are used in industry ?

0 Answers

out of all machines which have highest efficiency and why?

2 Answers

Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?

0 Answers

Hydro P.P. run @ 600 rpm,8pole, Nucler P.P @ 1500rpm 4 pole , ThermlP.P @ 3000 rpm 2 pole.Why this diffrence??? when we can generate electricity @ 600 rpm then Why we had incresed speed in NPP & TPP???

3 Answers

what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?

0 Answers

how we can calculate power factor without knowing current in 230v 100w load ?

10 Answers

Application wise, where we should use AC motors and where we should DC motors?

1 Answers Nespak,

For more Electrical Engineering Interview Questions Click Here