Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen to the core losses if we perform the open
ckt test on high voltage side of a transformer ?
- 2 Answers
- 4722 Views
- I also Faced
- E-Mail Answers
Answer Posted / eswara rao ch
Nothing but if we made the measurement on HV side it requires HV meters to find the same iron losses as found in LV side test which cause difficulty & expensive.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
block diagram of 2 ups system connected in parallel mode?
Why CBCT rating is 50/1A
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
What is difference between Over Current & Earth Fault protection?
Why human body feel electric shock?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
how to calculate current and voltage in a same circuit?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
What is the meaning of HT Trivector Meter ?
On what principle electric motor works?
What are the special cables required for explosion proof wiring?
how to failure indution motor insulation & how to improve heat in motor insulation
Whether power factor should be high or low? Why?
