Why the output of generator varies eventhough the shaft
speed is constant in thermal power plant?
Answers were Sorted based on User's Feedback
Answer / abhishek-gaur
n=120f/p
i.e speed dirctly proprtnal to freq
when load is increasd , speed decreases, so the frequncy ,
frequncy has to be maintained within a limit to prevent
appliances from failure...
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / k.prakashchandra
There is some defect in governor or pressure tank.When the
gen is connected to grid the speed remains constant as the
grid determines the speed.Check pf meter for fluctuations
also.These are teething problems in newly commissioned
gen.If the AVR is defective there will be fluctuations in
pf but not load
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / pandiya
due to stepup or stepdown transformer is my opinion
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / hardik085gmdc
It is ALL controlled by automatic voltage regulator,when we increase steam flow in turbine, stator current increase so generator terminal voltage decreased then for increasing voltage A.V.R increase excitation voltage and current SO MW INCRESE. OK
| Is This Answer Correct ? | 0 Yes | 1 No |
what is the practical definition for voltage
WHAT IS THE CONDITION FOR OPERATING DIFFERENTIAL RELAY IN POWER TRANSFORMER & WHERE IS NEUTRAL CT PLACED IN TRANSFORMER
What is GND Transformer?
Why motor is not calculated in kva, whereas transormers are calculated in kva
1. When do you use a VFD motor? 2. If the ceiling fan is on slow speed, does it consume less electricity? 3. If we want the fan to consume less electricity at low speed, what do we have to do? 4. What does “battery of 180 AMP HOUR” mean to you? 5. What does “battery of 180 AMP HOUR” mean to you? 6. If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
6 Answers Asian Power, Bhel, Focus, Focus Energy, L&T,
Earth bits close or open. Which is correct
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
What is the role of Tertiary Winding in Transformer ?
is EEE eligible for getting electrical supervisor certificate ? if yes then from which state i sud apply
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
What is the full form of SON-T lamp?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)