Why the output of generator varies eventhough the shaft
speed is constant in thermal power plant?
- 5 Answers
- 5680 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhishek-gaur
n=120f/p
i.e speed dirctly proprtnal to freq
when load is increasd , speed decreases, so the frequncy ,
frequncy has to be maintained within a limit to prevent
appliances from failure...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how does directional relay work incase of ac ?
in non technical way how can u define POWER FACTOR??
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What will happen if the voltage in my house drops from 220V to any lower voltage?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
during installation time of transformer and alternator which points we have to observed?
What are the roles and responsibilities of electrical engineer in cement plant
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What is the control action?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
what the function breaker failure scheme, how is it operated
what is the control circuit for operating the clean room air shower
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
