Answer / k ravinder

INTEGRATION OF((d(KWH)t/dt)/(d(KVAH)t/dt))=K, K=.95 LIMITS
0 TO t

What is inrush current?

0 Answers  

---

can i use 2000/5A Clamp meter to measure HT cable

0 Answers   century, Engro,

---

I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?

0 Answers   Bell,

---

what would happen if u assume to insulate all the overhead lines and no insulators....??do you think it to b an advantag or a disadvantage??justify.

3 Answers  

---

what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct

0 Answers  

---

how to find the resistance

3 Answers   Saint Gobain,

---

2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping

0 Answers  

---

What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?

0 Answers   HPCL,

---

Why there are semi conductor layers on conductor and XLPE insulation of HT cables

1 Answers  

---

flurescent bulb rating is to 230v,50HZ.now flurescent connected 230v,25HZ.whether nreduced frequency will affect the glowing properties of flurescent.

6 Answers  

---

what is power factor? how can we correction the power factor if this is high or low? If anyone know please please send the answer on my email id ( kumarkirshan@in.com )

5 Answers  

---

what is the meaning of rms value

24 Answers   Fitter, IOCL, OCL,

---