if a 3phase motor runnig in star delta starter with full load of its,and its r

if a 3phase motor runnig in star delta starter with full
load of its,and its rated 15 amps.now we conneted over load
thermal relay at its main contactor,here what will be our
amps sittings?

Question Posted / guest

3 Answers
5846 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if a 3phase motor runnig in star delta starter with full load of its,and its rated 15 amps.now we ..

Answer / pillay

If star delta connection it will have 6 wires . so the amp setting of the TOR WILL BE FULLLOAD AMPS /ROOT 3
15/1.732 =8.6 AMPS

Is This Answer Correct ?

6 Yes

2 No

if a 3phase motor runnig in star delta starter with full load of its,and its rated 15 amps.now we ..

Answer / tp

15 amp

Is This Answer Correct ?

2 Yes

5 No

if a 3phase motor runnig in star delta starter with full load of its,and its rated 15 amps.now we ..

Answer / k.prakashchandra

The thermal relay is coeected to mains and not after the
starter.The setting may be at 110 to 120 % 0f full
load.i.e.16 to 18 A

Is This Answer Correct ?

1 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

why always out of the 3 phase(RYB) of supply, in Y phase w.r.t the voltage is higher? on R & B phase the voltage will be lower as compared to Y phase?

1 Answers

Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient?

0 Answers

What is meant by SPS Aluminium pipe in substations? Anyone knows whats this?

1 Answers Amec,

if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .

0 Answers BSNL,

In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?

0 Answers

what is 33 /11kv transformer bdv

8 Answers NMDC, TPPL,

what is the problem in manufacturing transformer with 0 degree phase displacement.???why alwasys go for DYn11 or DY5?Whys not DY0 i.e zero degree displacement between primary and secondary side vectors?

3 Answers Bhel, dpdc, Prime Electrical,

how vector surge relay works ?

3 Answers BFL,

what is purpose of using reactor in substations

4 Answers NCC,

How much energy save vfd if motor run on 50 Hz (full speed)

3 Answers Reliance,

what is interference

1 Answers L&T,

why low pressure side of the turbine is connected to the alternator and not the high pressure side??

1 Answers

For more Electrical Engineering Interview Questions Click Here