Interested to Buy Any Domain ? << Click Here >> for more details...
if a 3phase motor runnig in star delta starter with full
load of its,and its rated 15 amps.now we conneted over load
thermal relay at its main contactor,here what will be our
amps sittings?
- 3 Answers
- 5978 Views
- I also Faced
- E-Mail Answers
Answer Posted / tp
15 amp
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
What are the advantages of nichols chart?
how can motor both beasrings insulation resistance can be check?
How to reduce -234126219.6403 MVAr generation and by what?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
What is the formula to calculate distribution transformer De-rating on iron losses basis
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
What is open loop and control loop systems?
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
Is any generator is developed which is operated with out diesal or other expensive source?
sir am giving jspl exam on 19th oct . i belong to eee, so plz send previous question papers ..........to dis id abhilash203@gmail.com
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
What is meant by celling voltage & current in excitor ?
Explain the method to keep noises low in a control system?
