EHV current carrying parts need to have smooth finish,then
how can a 245kv GIS with emery finish can run so long?
No Answer is Posted For this Question
Be the First to Post Answer
How will polarity test of Dy5 Transformer ?
what is meant by VFD ?where its useful ?
What does quality factor depend on in resonance?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
What is a formula to decide the size of the cable of the star delta motor ( From Contactor to the motor 2 runs )
if sf6 gas low in gis what will happen
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
What is the difference between "Earthing" and "Neutral"?
Dear all, Can anybody tell me that how to choose CT for a specific load? I have a 200kw induction motor, which ratio CT should be installed? Is there a formula or calculation that determines the CT ratio for a load? Regards.
Ferranti Effect says that voltage at the receiving end is higher than that at the sending end. How is it possible?
How to increase solar cell efficiency ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)