Interested to Buy Any Domain ? << Click Here >> for more details...
On an ISDN BRI interface, the control channel is the 'D'
channel.
What is
the rate of this channel?
A.) 64 Kbps
B.) 1.544 Mbps
C.) 128 Kbps
D.) 2.048 Mbps
E.) 16 Kbps
- 2 Answers
- 5507 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / rajbir singh mor
Interface for providing two data channel (B channels,
64,000 bps each ) and one control channel (D channel,
16,000 bps). Link between Basic Rate Interface and terminal
equipment is S0 bus. (also called as S/T interface).
| Is This Answer Correct ? | 4 Yes | 0 No |
Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP
which points are eliminated by the DBSCAN algorithm?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
what is the difference between dynamic NAT and NAT overload ? and how it works ?
Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco
Which layer is responsible for providing mechanisms for multiplexing upper-layer application, session establishment, and tear down of virtual circuits? A.) Session B.) Network C.) Physical D.) Transport E.) Application F.) Presentation
In transport layer, for connection oriented communication Three way handshake process is there to establish a connection. So question is that, when a host send an ACK messages to another host with host intend to establish a connection, the source host send it as Broadcast or unicast message? Cud anyone explain this. Thanks in advance.
What is the Function of Layer3 Switch?
What is formula of hold down time of eigrp protocol?
Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance
what is ip address and what is the difference between the ip address and mac address why we are not using mac address instead of ip address
Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
CCNA 
