Interested to Buy Any Domain ? << Click Here >> for more details...
Identify 3 characteristics of IP RIP?
A.) Distance vector
B.) Administrative distance is 120
C.) Periodic updates every 60 seconds
D.) Uses a composite metric
E.) Can load balance
- 1 Answers
- 4770 Views
- I also Faced
- E-Mail Answers
The -- terminal no editing -- command will perform what function? A.) Edit the contents of NVRAM B.) Allows access to the terminal port C.) Stops the advanced editing feature D.) Enable password functions
What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a
When a Distance Vector routing protocol detects that a connected network has gone down, it sends out a special routing update packet, telling all directly connected routers that the distance to the dead network is infinity. This is an example of which routing technology? A.) ICMP. B.) Only Link State routing protocols have this intelligence. C.) Triggered updates. D.) Garrison-4. E.) Split Horizon. F.) Poison Reverse.
Differnce between the communication and transmission?
hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha
0 Answers ALU, TATA, Volvo, Wipro,
Define the different kinds of casting
How many (minimum and maximum) ports are present in a router?
Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured
hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
Which three basic switch functions increase available bandwidth on the networks? (Choose three) A. loop avoidance B. address learning C. hop count limiting D. broadcast filtering E. packet forward/filtering F. broadcast packet hop count learning/forward/filtering
Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol
Which command will display adjacent routers found by the Cisco Discovery Protocol? A.) show all B.) show cdp entry C.) show ip neighbors D.) show cdp neighbor detail E.) show cdp neighbor F.) show neighbor
CCNA 
