Which of the following would be displayed by the command
'SHOW CDP

NEIGHBOR DETAIL'?

A.) The incoming/outgoing port.

B.) The hardware platform.

C.) One address per protocol.

D.) Amount of Flash Memory Available

E.) The routers hostname.

F.) The subnet mask, if IP is configured.



Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? ..

Answer / guest

Answer: A B C E

CDP shows a lot of the same info that 'show version' does
locally, but

FLASH memory is not part of it. The 'detail' keyword is
optional, but

even when used, IP subnet mask information is not displayed
by CDP for

IP interfaces.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More CCNA Interview Questions

Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  


Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 Answers  


Which processes does TCP, but not UDP, use? A. Windowing B. Acknowledgements C. Source Port D. Destination Port

2 Answers   Lucent,


What is BGP Synchronization rules?? Can any one explain..???

2 Answers   Hathway,


Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment

1 Answers  






What is the regional telco office called, where the customers local loop terminates? A.) Demarc B.) DTE C.) DCE D.) CO E.) CPE

1 Answers  


What is the default bandwidth of a serial connection? A.) 1200 baud B.) 1.544 Mbps (T1) C.) 10 Mbps D.) 96Kpbs

4 Answers  


Explain the difference between routable and non- routable protocols?

0 Answers  


Hi, I am littl bit confused about ip Addressing scheme? can someone tell me how can we assign ip addresses to pc

2 Answers  


Tell me CCNA Course + Dump Q/A in chennai?

2 Answers   Microsoft, Wipro,


Mention what is bootp?

0 Answers  


Identify the hardware component used to store buffers, tables, running-configuration etc? A.) NVRAM B.) ROM C.) RAM D.) Flash

4 Answers  


Categories