How many Frame-relay encapsulation types are available with
Cisco
routers?
A.) Four
B.) Two
C.) Five
D.) Three
- 2 Answers
- 10375 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / m haja bahurudeen
Ans : B
1) Cicso
2) IETF (Internet Engineer Task Force)
Cicso
Frame relay connected between two cisco devices
IETF (Internet Engineer Task Force)
Frame relay connected between cisco and non cisco devices
| Is This Answer Correct ? | 5 Yes | 1 No |
What are four ways that Fast Ethernet compares to 10BaseT Ethernet? (Choose four) A. Fast Ethernet uses the same Maximum Transmission Unit (MTU) B. Fast Ethernet is based on an extension to the IEEE 802.3 specification C. Fast Ethernet uses the same Media Access Control (MAC) mechanisms D. Fast Ethernet preserves the frame format that is used by 10BaseT Ethernet E. Fast Ethernet errors a speed increase one hundred times that of the 10BaseT Ethernet
'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers
What is the subnet? Why is it used?
When using TCP, after a session is open, the applications can adjust the amount of segments they receive before sending an acknowledgment. This behaviour is known as ______________. FCS Windowing MTU adjustment Flexible Send Path
An autonomous system can only exist if all routers in that system meet which criteria? A. interconnected B. run the same routing protocol C. assigned same autonomous system number D. run IGRP only E. run RIP only
What is the link state routing protocol in the TCP/IP protocol stack? A. IP B. IS-IS C. NLSP D. OSPF E. RIP version 2
Which 3 statements describe default encapsulation and LMI type configuration? A.) There are only 4 encapsulations and 3 LMI type options B.) The LMI type config term options C.) In release 11.2 the LMI type is autosensed D.) The default LMI is Cisco E.) IETF encapsulation must be configured unless the connecting routers are both Cisco
Explain what is overlaod?
What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.
Tell me which multicast ip eigrp protocol use?
Which of the following is an example of the Datalink Layer? A.) LLC B.) TCP C.) SQL D.) IPX E.) Token Ring F.) MAC
Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP
CCNA 
