Answer / nataraj

D)enable secret Cisco1 is the best answer.

Answer / guest

Answer: C

In port based access-list which command u give instead of ip?

0 Answers  

---

When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised

8 Answers   Wipro,

---

Which protocol switch use for filling its mac-table?

0 Answers  

---

Which show underrate serial 1 status statement indicates that the shutdown command was issued on that interface? A. Serial 1 is up line protocol is up B. Serial 1 is up line protocol is down C. Serial 1 is down line protocol is down D. Serial 1 is administratively down the line protocol is down

2 Answers   Pioneer Labs,

---

Which of the following provide correct information about a protocol at the transport layer of the OSI model? A.) UDP - Provides Connectionless datagrams service B.) TCP - Provides Connection Oriented Services C.) SMTP - Provides Mail Exchange D.) IP - Route determination E.) TCP - Provides Flow Control and Error Checking F.) FTP - Transfers of Files

2 Answers  

---

Choose the following that are benefits to segmenting with router: A.) Flow Control B.) Manageability C.) Multiple Active Paths D.) Explicit packet lifetime control

1 Answers  

---

Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network

2 Answers  

---

The ICMP (referred to in PFC 1700) is implemented by all TCP/IP hosts A. true B. false

1 Answers  

---

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network

1 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains

1 Answers  

---

Why do we have a Layered Model? 1) It reduces complexity 2) Allows for a standardized interface 3) Facilitates modular engineering 4) Ensures interoperable technology 5) Accelerates evolution 6) Simplifies teaching and learning

1 Answers  

---

what is lmi? how many type of lmi's we are using ...

1 Answers  

---