All equipment located at the customers site is called:
A.) CPE
B.) CO
C.) DCE
D.) Demarc
E.) DTE
Q: why are switch trunking modes ( dynamic auto , dynamic desirable )used in switch while trunking? if only negotiation is the factor it can be done with one mode as well ie dynamic desirable . but why we need dynamic auto. coz it dsnt negotiates ..at all please post answer asap thanks :
Which statement is true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not a the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth
When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes
Which layer hides details of network dependent information from the higher layers by providing transparent data transfer? A.) Transport B.) Physical C.) Data Link D.) Session E.) Application F.) Network
what is prefix list
Can you define in short what VPN is?
Identify the 2 commands to copy a configuration from a TFTP server to RAM? A.) configure network B.) configure overwrite C.) copy backup-config running-config D.) copy tftp running-config
Identify the 3 guidelines for routers in the same autonomous system? A.) Must be configured for RIP B.) Interconnected C.) Assigned the same autonomous system number D.) Configured for the same routing protocol E.) Must be same model of router
Tell me how much hold down time of eigrep protocol?
Which command will display Ethernet 0's IP address? A.) display ip address e0 B.) show ip interface e0 C.) show address e0 D.) sh ip address e0 E.) show all
Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25