Identify the extended IP access-list number range?
A.) 600 - 699
B.) 1 - 99
C.) 900 - 999
D.) 100 - 199
- 2 Answers
- 3990 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: D
The extended IP access-list range is 100-199.
| Is This Answer Correct ? | 3 Yes | 0 No |
Which ISDN specification deals with call Setup and Teardown? A.) Q-Series B.) J-Series C.) I- Series D.) C- Series E.) F-Series
When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised
What is true about frame-relay DLCI? A.) DLCI represents a single physical circuit B.) DLCI is optional in all frame-relay networks C.) DLCI identifies a logical connection between DTE devices D.) DLCI is used to tag the beginning of a frame with VLAN information
What is Summarization and supernetting and what its use?
hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha
0 Answers ALU, TATA, Volvo, Wipro,
Identify the command that displays traffic statistics on serial0/1? A.) display interface serial0/1 B.) show interface serial0/1 C.) show seria0/1 stats D.) show interface serial0/1 stats
What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category
Access lists are numbered. Which of the following ranges could be used for an IP access list? A. 600 - 699 B. 100 - 199 C. 1 - 99 D. 800 - 899 E. 1000 - 1099
What metric does rip use? How is the metric used to indicate an unreachable network?
What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging
What is the syntax to add a banner to the Cisco router? A.) motd banner # B.) banner C.) banner motd # D.) banner #
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
CCNA 
