Answer / g.v.hema chandu

The processing of connecting of all neutral terminals of ckt
to ground is called grounding.
The process of connecting the electrical appliances to earth for an safety is called earthing

Answer / prabhakar jha

grounding is the equipment safety & earthing is controll fault current to ground.

Answer / gokulkumar

actualy gmd & earthing are same concept but main diff.is
eart is gender of the gnd so earth is allwayes 0 pottential
as compair to gnd

Answer / a

grounding is for equibment safety and earthing is for Human
Safety

Answer / pmaruthi

both are same but Earthing term is used in electrical
equipments and Ground is used in electronics Equipment.

Answer / nash

grounding is necessary for equipment's safe operation..
earthing is essential for the safety of the personnel who is
working..

Answer / raghu

grounding

Answer / fdadef fef

grounding is same as earthing

Answer / ajay

grounding is nothing but leakages of currents and protect
the whole system to ground the neutral and earthing is
nothing but protect the system of particular system directly
connect to neutral.

Answer / kundan malani

grounding is use in electronics equipment up to 50 voltage
earthing is use in electrical equipment up to high voltage

for 5KW resistive load can anyone please suggest me whether to go for UPS/Inverter or Generator depending upon cost calulations

0 Answers  

Why does the phase voltage of two healthy phases become equal to the line voltage in case of an ungrounded neutral 3 phase star connected sytem when a single line to ground fault occurs ?

2 Answers  

why power dissipation is due to low frequency?

1 Answers  

In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.

2 Answers  

How can we have to decided motor connection as a STAR-DELTA or DELTA-STAR?

3 Answers   IOCL, Jindal,

what is meant by boost charge in batteries

1 Answers   MTS,

What is the rating of HT SUBSTATION and LT SUBSTATION?

11 Answers   NTPC, Sail,

WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?

0 Answers   L&T,

How to synchronization will be done between two DGs ?

0 Answers  

how to deside the capacity of chock for drive?

0 Answers   Essar,

Differcence between UPS and Inverter.

4 Answers   Adani,

The following equipment are installed ia a plant 1. 110KW Induction motor 4 Nos 2. 30 HP motor 3 Nos 3 15 HP Motor 3 Nos 4 7.5 HP motor 4 Nos what is total load of plant if one of each is stand by.

3 Answers   Blue Star,