i am BSEE student, my project study is to synchronize the generator of an hospi

i am BSEE student, my project study is to synchronize the
generator of an hospital, it have a one 313KVA standby-power
diesel gen.,and three 100kva transformer.The generator
system is operated manually and no ATS or UPS. one more new
building is being build so the transformer will be upgrade
to a higher vale.
1)how i can connect the new gen. to the old gen. and to the
synchronize panel?
2)what is the new gen. to be buy?(rating, etc.)

These is my title: To synchronize the generator system of
the ____ Hospital.
Anyone have a good title?
Thanks.

Question Posted / dhanking23

1 Answers
3070 Views
I also Faced
E-Mail Answers

i am BSEE student, my project study is to synchronize the generator of an hospital, it have a one 3..

Answer / kpd

What are you synchronising to? Are you synching to another
generator for load sharing or synching to the mains?

If mains are you synching for export or are you back
synching for bumpless (or no break) return to mains on
restoration? Arew your site transformers fed from the same
ring? If not you'll have all kinds of issues.

Either way the big thing to get in there is your very
expensive G59 testing and approvals before any DNO will
allow any synchronisation. Also the protections in your
generator control to prevent any out of parallel closing to
mains (makes a BIG mess) check syncs etc etc

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

Why is tan-delta test and capacitor measurement done on alternator?

0 Answers TD Power Systems,

When should I use earth leakage circuit breaker for incomer and when should I use it for each feeder seperately?

1 Answers

what is the working principle of Brushed alternator ? without exictation how we can give dc supply to rotor ?

1 Answers

What does dny11 stand for?

5 Answers Cenored,

where solid grounding and where grounding through ngr done and why?

0 Answers NTPC,

During he starting up of the motor, the upstream's MCCB (350A) always trips due to the UVT relay activated. Can Star-delta starter use for a 20kW Motor (For a powder mixer machine) cause voltage-dip in the supply line voltage? If so, what are the recommended solution to eliminate/reduce the transient voltage dip in the line voltage?

4 Answers

what is Wave Trap? And its Function ? Detail? Where it is Used?

7 Answers

what is active network?

2 Answers

Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks

0 Answers

What is the use of insulation tester and how it is to be used.

2 Answers

How can transformer oil be used in transformers with voltage rating above its breakdown voltage?

2 Answers

why excitor coil of an alternator can fail

3 Answers

For more Electrical Engineering Interview Questions Click Here