Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the effect of Ctrl-Z?
A.) Exits back to privileged exec mode
B.) Disconnect from the router
C.) Abort the ping operation
D.) Exits privileged exec mode
- 3 Answers
- 5893 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / murthy
if we execute this command we'll exit from privileged to
exe moda
| Is This Answer Correct ? | 1 Yes | 1 No |
IP standard access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) port C.) protocol D.) source address
Which of the following are valid WAN terms? A.) DTE B.) DCE C.) Demarc D.) CPE
I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category
If i connect two routers through ethernet cable and serial cable then which has high speed and which is better among two?
10 Answers Compaq, Inspace, Wipro,
Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register
The Integrated Services Digital Network (ISDN) Basic Rate Interface (BRI) provides which of the following? A.) 1.544 Mbps B.) 23B + 1D Channel C.) 24B + 1D Channel D.) 2B + 1D Channel E.) 23B + the Disney Channel
Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department
What is the difference between bus topology and hub?
Identify 3 LAN technologies? A.) FDDI B.) HDLC C.) HSSI D.) X.25 E.) 802.3 F.) 802.5
On a network design project you determine that a new testing application requires multiple hosts. These hosts must be capable of sharing data between each host and an enterprise server at 10 Mobs bandwidth. Other divisions in the company use applications that require less than 2 Mobs bandwidth of the enterprise server. What is your most economical recommendation? A. That existing 10BaseT hubs be replaced with 1 00BaseT hubs to improve overall performance B. That a router can separate the testing application from the rest of the network, thus allowing the testing application more bandwidth. C. That a switch be installed, so that the enterprise server can be provided a 100 Mobs pod and each of the testing application hosts can be given dedicated 10 Mobs pods] D. That a bridge be placed between the enterprise server and all other users with the exception of the testing application
Can anyone explain in details port fast, uplink fast & backbone fast features introduced by CISCO (The GOD FATHER of NETWORKING.... Hehehehehe).
CCNA 
