Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains

1 Answers  

---

Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory

2 Answers  

---

Which layer are called upper layer?

0 Answers  

---

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

3 Answers  

---

What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?

20 Answers   IBM,

---

Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router

1 Answers  

---

what is bgp i have ansered all of them except mpls while i am working on it but i donot have threotical concepts on it the told me that they are keeping me on hold let try urs knowledge all the best

1 Answers  

---

If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through

2 Answers  

---

Which layer allows multiple Ethernet devices to uniquely identify one another on the Datalink layer? A.) Transport B.) Session C.) Network D.) Datalink - MAC Sublayer E.) Datalink - LLC Sublayer

3 Answers  

---

What is the mau?

0 Answers  

---

What are some standards supported by the Presentation layer?

0 Answers  

---

You receive "input filter list is 800 and output filter list is 801" as part of the output from a show interfaces command. What kind of traffic are you filtering? A. IPX/SPX B. TCP/IP C. LocalTalk D. DDR

1 Answers  

---